Future Pile is a cylindrical pile designed to be driven directly into the river or sea bed using conventional equipment.

​

These are an ideal replacement for timber, steel or concrete in new installations or where the deck structure can be removed.

​

A 1m section of the 475 FuturePile was tested in compression up to a serviceability load of 1500kN and showed no sign of damage.

Future Brace is a composite fibre bracing structure, in three engineered profiles (Solid Rectangular Section, Equal and Unequal Angle Profiles). Designed to replace ageing timber braces and manufactured with a state-of-the-art resin infusion process.

​

These braces are retrofitted to existing bridge and wharf structure with little to no interruption to traffic access and will last longer than timber.​

The Future Beam girders are designed to provide equivalent bending rigidity to a new timber girder and are slim enough to fit between existing girders to greatly reduce the cost associated with removing the un-serviceable timber girders.

Future Deck a one-piece fibre composite (FC) decking panel system.

This creates a light-weight, integral structure with much reduces installation costs and site work. 

​

This system can accommodate both pedestrian loads of 5kPa as well as vehicles up to 6,100kgs currently, on variable support centres.

​

​

Future Jetty is a composite fibre jetty/wharf structure where the beams, cross beams and decking are made as a single, integral part using a state-of-the-art resin infusion process.

​

A complete jetty is retrofitted to existing abutments with little to no interruption to service and will last longer than timber.​

FutureJacketTM is attached around the degraded piles to reinstate it to its orginal design loading, by encapsulating & bridging all deteriorated sections.

FutureWrap is an environmental only protection and is used mainly on bew timber, steel or concrete piles to give them the longest life in service.

​

As a physical barrier between the pile and the elements, sea water, tidal erosion and marine borers, the solution is easier to install than other similar products available today. 

FutureJoint is a simple and easy to replace degraded timber sections for severely deteriorated piles.

​

Without removing the decking the damaged segment is removed and a composite joiner installed. Then a new pile header is fitted and stood up into place under the bridge or wharf beams.

Future Bridge is a composite fibre bridge structure where the beams, cross beams and decking are made as a single, integral part using a state-of-the-art resin infusion process.

​

A complete bridge is installed with little to no interruption to traffic access and will last longer than timber.​